- Determine the value of resistance by colour code and identify types.
- Test active and passive electronic components and its applications.
- Determine V-I characteristics of semiconductor diode.
- Construct half wave, full wave and bridge rectifiers using semiconductor diode.
- Check transistors for their functioning by identifying its type and terminals.
- Bias the transistor and determine its characteristics.
- Use transistor as an electronic switch and series voltage regulator.
- Operate and set the required frequency using function generator.
- Make a printed circuit board for power supply.
- Construct simple circuits containing UJT for triggering and FET as an amplifier.
- Troubleshoot defects in simple power supplies.
- Construct power control circuit by SCR, Diac, Triac and IGBT.
- Construct variable DC stabilized power supply using IC.
- Practice on various logics by use of logic gates and circuits.
- Generate and demonstrate wave shapes for voltage and current of rectifier, single stage amplifier and oscillator using CRO.
- Design layout of control cabinet, assemble control elements and wiring accessories for:
- (i) Local and remote control of induction motor.
- (ii) Forward and reverse operation of induction motor.
- (iii) Automatic star-delta starter with change of direction of rotation.
- (iv) Sequential control of three motors.
- Carry out wiring of control cabinet as per wiring diagram, bunching of XLPE cables, channeling, tying and checking etc.
- Mount various control elements e.g. circuit breakers, relays, contactors and timers etc.
- Identify and install required measuring instruments and sensors in control panel.
- Test the control panel for its performance.
- Perform speed control of DC motor using thyristors / DC drive.
- Perform speed control and reversing the direction of rotation of AC motors by using thyristors / AC drive.
- Construct and test a universal motor speed controller using SCR.
- Assemble circuits of voltage stabilizer and UPS.
- Prepare an emergency light.
- Assemble circuits of battery charger and inverter.
- Test, analyze defects and repair voltage stabilizer, emergency light and UPS.
- Maintain, service and troubleshoot battery charger and inverter.
- Install an Inverter with battery and connect it in domestic wiring for operation.
- Draw layout of thermal power plant and identify function of different layout elements.
- Draw layout of hydel power plant and identify functions of different layout elements.
- Visit to transmission / distribution substation.
- Draw actual circuit diagram of substation visited and indicate various components.
- Prepare layout plan and Identify different elements of solar power system.
- Prepare layout plan and Identify different elements of wind power system.
- Assemble and connect solar panel for illumination.
- Practice installation of insulators used in HT/LT line for a given voltage range.
- Draw single line diagram of transmission and distribution system.
- Measure current carrying capacity of conductor for given power supply.
- Fasten jumper in pin, shackle and suspension type insulators.
- Erect an overhead service line pole for single phase 230 V distribution system in open space.
- Practice on laying of domestic service line.
- Install bus bar and bus coupler on LT line.
- Identify various parts of relay and ascertain the operation.
- Practice setting of pick up current and time setting multiplier for relay operation.
- Identify the parts of circuit breaker, check its operation.
- Test tripping characteristic of circuit breaker for over current and short circuit current.
- Practice on repair and maintenance of circuit breaker.