3 july 17

ELECTRICIAN
(PRACTICAL)
SEMESTER-m
TIME: 8 Hrs.
MARKS: 270
Toter Atempt all the question Aitquestions carry eqral marks

1. Study of voltage building of the alternator and draw the load characteristics.
 

2. Explain the construction working and operation of a syrichronous motor.

 

3. Explain and draw the connection and working of autotransformer starter.

*****

3 jan 18

ELECTRICIAN
(PRACTICAL)
SEMESTER-III
TIME: 8 HRS.
MARKS: 270
Note: Attempt all the questions.
1. Take a dismantled 1-phase capacitor start motor. Make the connections and start it and then  make the connections to run the motor     in opposite direction.
 

2. Perform an experiment to soft start 31 induction motor by star-delta method.
 

3. Do skinning of 31/2 core cable and fix gland and thimbles and make connection between the
power/control panel and 3-phase induction motor.

 

2 july 18

ELECTRICIAN
(PRACTICAL)
SEMESTER-II
TIME: 8 Hrs.
MARKS: 270
Note: Attempt all questions. All question carry equal marks.

1.  Test and study the Half Wave and Full Wave rectifier circuits with and without Filter
     Circult. Show the Various Wave Form on CRO.

2.  Measure the various voltages and currents of a Single-Phase Transformer and find out the
     efficiency & regulation of the transformer.

2 july 17

ELECTRICIAN
(PRACTICAL)
SEMESTER-II
TIME: 8 Hrs.
Note: Attempt all questions.

1. Study of full wave bridge rectifier and calculation of full wave bridge rectifer's outgut
signal parameters with CRO.

 

2. Test the following test of a given single phase transformer.

a) Open Circuit Test
b) Short Circuit Test
c) Efficiency of Transformer. By direct loading method/ By calculating the toal losses.

 

3. Describe the starting of shunt motor by a four point starter with diagram and start the motor

2 jan 18

17IA/C/S-2/4/E
33/231
ELECTRICIAN
(PRACTICAL)
SEMESTER-II
TIME: 8 HRS.
MARKS: 270
Note: Attempt all questions.

1. Make a circuit of a full wave center tap rectifier on a breadboard and see the
waveforms on C.R.O at various points and write down their values.

2.To determine the efficiency of D.C. shunt motor and its performance characteristics.

3.Take two exhaust fans and do wiring in such a way that only one fan is ON at any
given time or both are OFF using appropriate switches.

Sem - 2 2/July/ 2018

ELECTRICIAN
(PRACTICAL)
SEMESTER -II
(SESSION 2017-2018) - NSQF LEVEL-5
TIME: 8 HRS.
MARKS: 270
Note: Attempt Any three questions. All questions carry equal marks.

1.  Assemble house wiring including carthing for 1-phase energy, mater MCB. ceilina fan, tobe ighi, three pin sockel and a lamp operated from two different positions.    Demonstrate the basics fonctional study of components used in house wiring.

2. Prepare pipe / plate earthing and measure earth resistance by earth tester/ megger.

Sem - 1 1/July/2017

ELECTRICIAN, ELECTROPLATOR, LIFT MECHANIC/LIFT& ESCALATOR
MECHANIC, WIREMAN
(PRACTICAL)
SEMESTER-
MARKS: 270
Note: Attempt all questions. All question carry equal marks.

1. Plot and demonstrate the working characteristics of PN junction diode and Zener diode.

2. Demonstrate and draw the connection diagram of staircase lighting arrangement using the two way switch.

Subscribe to